Last Modified: 11-29-2007 1.6 A
Service Category: Engine/Hybrid System Section: Starting
Model Year: 2008 Model: Sequoia Doc ID: RM000002MDK00BX
Title: 3UR-FE STARTING: STARTER: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL STARTER ASSEMBLY

(a) Install the flywheel housing side cover.

(b) Install the starter with the 2 bolts.

Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)


(c) Install the water by-pass pipe bolt.

Torque: 18 N·m (184 kgf·cm, 13 ft·lbf)


(d) Install the starter wire with the nut.

Torque: 9.8 N·m (100 kgf·cm, 87 in·lbf)

(e) Connect the starter connector.

2. INSTALL STARTER COVER

(a) Install the starter cover with the 3 bolts.

Torque: 12 N·m (122 kgf·cm, 9 ft·lbf)

3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 Sequoia)+

4. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 Sequoia)+

5. INSTALL FRONT NO. 3 FLOOR HEAT INSULATOR 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 Sequoia)+

6. INSTALL FRONT EXHAUST PIPE ASSEMBLY 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 Sequoia)+

7. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

(a) Apply a light coat of engine oil to a new O-ring.

(b) Install the O-ring to the guide.

(c) Install the dipstick guide with the bolt.

Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)

(d) Connect the wire harness clamp.

(e) Install the dipstick.

8. INSTALL FRONT FENDER APRON SEAL RH 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 Sequoia)+

9. INSPECT EXHAUST GAS LEAK 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 Sequoia)+

10. INSTALL NO. 1 ENGINE UNDER COVER 3UR-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 Sequoia)+

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 Sequoia) .